Recent content by Casselfornia

Any chance you could tell me what Eproms to use? Or anyone else?

Let me know once you've tried if it helped. ;)

Did anyone attempt to blindly replace the usual RAM? IC16,18,20,22? I got two of these revisions and they do not boot. Fans spin, voltage is there.

Definitly check the voltages first. N2 is possibly dead because of overvolting it.

Is Ken still active here? Got an Naomi 1 Rev. D board with all factory repairs except the one that runs to the Diode and the X76F100, both Fans spinning but not booting. All voltages are good and most importantly the LED's DO NOT LIGHT UP! What could this be? IC 41 and Bios are all good and have...

Can somebody tell me how I can convert my Rad Mobile pcb to Slipstream? I fixed my spare Romboard.

I have the board but I am missing the cables. I already traced all the connections with the schematics yesterday - I just want to make sure. I am running the whole thing without the filterboard so there are some differences. I connected to the DIN 50 Pin connector that drives the outputs but...

Thanks mate. That should help me figure it out. Can I get a close up of connector 5? I need the cable colors! Too bad I cannot find the necessary parts to build the orange cable. Gotta try that with a JTAG header then. Again, thank you Galileo! <3 BTW: If anyone needs this - I have the...

Bump, anyone?

Thanks for sharing. Could you add a better Photo of the Eproms for archival purposes?

I have the PCB, the Radio Control with Display and the PCB without any wires. I had a look at the schematics but I don't know how the 14 Pin display connector is being accessed by the Main PCB. So if anyone could help me figure it out who owns one of these machines I would be very thankful...

The problem is that the board didn't start without the Afterburner Test roms. I'll buy a desoldering iron soon and will give it another shot. Thanks for your input! Don't hesitate to add more :)

Yaton has one of the radio panels available. ☝️ Meanwhile I am in a bit of struggle connecting the radio unit to my PCB without the 839-0583. Can someone tell me which pins connect to the 14 pin LCD connector and in which order? From the filter board.

Added to the backlog for later. I need a new desoldering station. Removing ics with the manual vacuum pump isn't really getting me anywhere. I am scared to destroy traces. I will report once I got a new one. 👍

I sold mine as I was out of ideas.