Recent content by Hadouken Arcade

Sorry, I need to update the design but my usual ME availability isn't so great. I'll place an order ASAP. I expect it'll be available around mid Feb. I updated the web page to for pre-order. I updated the main posting for details.

I setup my ttx3 with joy2key to use brook fighting board. I noticed some lag and changed the setting in joy2key to max polling rate (make sure to do this). Once that was done I couldn't feel much difference between FastIO and brook fighting board.

that was fast

I used a taito JVS and it was beyond playable. Some games were slowing down for some reason. Could be the JVS implementation with this multi.

Bingo. Got the right part. See this post

I think I found it. http://t-tatsumi.com/wp/wp-content/uploads/2014/10/sj9.pdf PN: YKB21-5352N I compared some of the dimensions and they're a match so far. The question is, where the hell do can I buy these? https://www.connectorpeople.com/Connector/JALCO/Y/YKB21-5352 It's missing a N at the...

I have like 6 boards to repair so I want to see if there is an option first. I did look up before but did not find anything close. The jack says Jalco. I think this is the connector manufacturer but didn't really lead to anywhere.

Hello, Does anybody know the part number for this audio jack? I have several amps that need a replacement. I tried to source the part a while ago but had no luck. Worst case I'll just solder something... any direction is appreciated

It really depends on what kind of tool you have. I used a Dremel but took forever on a aluminum version. Maybe there is a better way though. I would drill series of holes around where you want the cut out to reduce using a Dremel the whole time.

Yes, Rev C works. I have the exact monitor. Early rev will have to make a cutout. This monitor sits quite low so you won't be able to access the control thingy on the bottom of the monitor through the small cutout. Because the bezel is so thin I recommend applying the gasket on the glass instead...

I'm still interested :D

I'll take one :)

I'm back. Sorry about the MIA. I was going through some dynamic situation that I had to step away for a while. I updated the store and currently accepting orders.

pmed

Correct. the job button is awkward to use but still accessible.