Recent content by mob-z

Yes I remember those! I've seen other ones which seem to utilize SD cards, I haven't tried them, and not sure if it will though.

But in any case, I haven't seen any tbh. I don't know if they even existed back then 🤷🏻‍♂️

I haven't seen any, but I wouldn't be surprised. There were Genesis/Mega Drive copies or bootlegs of games back then, so there could be third party cards which we might not even know that it existed.s Sorry I must've posted without completing my sentence 😅.

I haven't seen any, but I wouldn't be surprised. there were Genesis/Mega Drive

Hello BuddyC: I know this is an old thread, but for the last 2 stickers, I was able to figure out where the small one goes, while still looking where does the second one (the one with the finger) would actually fit. I have attached a photo for the smaller sticker as where it is supposed to...

At last! I was able to complete this project and the results are amazing! I am very happy how it turned out! This cab has seen worst days, but I promise to give it a good home 😄 I will definitely be continuing on a new thread for my last part which will cover the marquee and its...

I've been quite busy last week and wasn't able to post any updates, but at least I was able to pick up the cabinet from the paint shop, and the results are great! I will let the picture do the talkin'.:D Hopefully my last step is to assemble the whole cabinet and see how it would look like...

After struggling with paint removal, I have finally finished the hard part. This process took quite a bit of time, which took around 2 weeks to remove the old paint. I was able to take the cab to a body shop last weekend for a final clean-up and a fresh coat of paint. I had left the inner...

More paint stripping To be continued...

I Started to remove the paint from the cab, I was struggling with this as it was one layer of paint after the other. This is due to the fact that the service dept in the gaming center did a poor job servicing their cabs, mostly repainting on top of the original paint, either using a paint brush...

The next step is to remove all the wiring and put it aside for the time being, keeping in mind where all those ground wires go when rewiring. I might need to change the control panel overlay since it looks a bit worn out! I will try to give it a bit of cleaning if it helps, probably towards...

I have been putting of this project and prolonging it for quite some time, trying to find an excuse to stay away. But I have decided that it is time. When I first started working on the cab, I had power issues (not enough power to run the main motherboard). The screen would turn on, but it...

Any updates on the marquee? would love to see some teasers :D

Looking forward to it 😍. I would appreciate if you could compare the screw holes in my drawing with the marquee holes, if I did it correctly it should match. If not, let me know where to adjust and I will do it accordingly. Thanks.

I had some time this weekend to draw the Marquee holder and the marquee base holder. Special thanks to @nem for providing precise measurements and @joeks for providing feedback. I would appreciate any feedback on the drawings. For whomever want to laser cut the parts, please feel free to use...