Recent content by Soundmazta

I had a simulor issue when I upgraded my house of the dead sdlx to a new flat screen with no vga input. The problem is that you can use hdmi or dvi with a passive adapter on an vga input, but it's not working the opposite way. I had to buy an vga to hdmi adapter which also needs 5volt. I took...

You are right I think I should get a newer cab with model 3 dash, throw in an ringedge driveboard and everything is fine :-). Just thought I could use my old 4 piece of Sega Daytona usa cabs and convert them to flat-screen and the new software. That what came in my mind. I love Daytona and I...

Sega racing classic is running on ringwide but has model 2 dash. Also the drive board looks like a remake of the original Sega usa drive board. The new Sega Daytona is running with happ drive board and dash just like Sega rally 3, Sega grid...

Does anybody know if the new Daytona and maybe also Sega classic racing is using the old model 2 dash? I had a look into both manuals and they look very simular.

I always thought noir and Lindbergh are the same..

Are the two tekken cabs linked? Both are group a red...

I would like to buy a selector please.

Sorry guys was my fault. Sometimes i tried to booted jumper settings that do not exist.. Now all is working as it should. :-)

sorry what is sh 2 ;-)

I installed the wire but the problem is still present. I have to start a few times before a new game is loaded. Sometimes 2 times, sometimes 10 times its strange...

I bought it last December so I should have the new firmware and must only install the wire?

Yes what I thought, but when I change the jumpers then often it reloads the already booted game and doesn't install a new one. That's why I was asking. Didn't want to install the reset wire cause I them also have to update the firmware I thought...

I didnt install the wire. I changed jumpers and was able to boot a game after the error screen. Afterwards reboot and jumper changed had no effect .even after a few reboots the game didnt change so i was thinking that the card has to be powered down for a few minutes after jumper changig. thats...

thank you for your answer Darksoft. I first tried the same games but i wasnt able to boot them. Maybe was my fault now another game booted. Maybe i havent waited long enoughh after the first boot to install the game from the sd to the card. Changed the jumpers and waited a few minutes with error...

I have a problem with my multicard. Games show up in Testmenu but are not starting. Iam getting black screen and nothing shows up. I tested on 2 boards. Both boards have the multi bios installed and are working with original cards. I already tried to adjust the voltage nothing worked. Hope...