Recent content by trashedcabs

Weekend bump

Ever since I hit the opamp with cold spray it hasn't wobbled, so I decided to install the monitor today. Once the replacement part arrives from China in a few weeks I'll take the chassis out again, but it's real annoying to get to the anode cup with the rotation mech in the way. At the...

MS8-29 Symptom: Horizontal twitching, deflection protection being triggered randomly I noticed if I maxed out H Subsize and the H Size pots the twitching problem went away, or if I maxed out the SPC control which is also connected to H size the problem would go away on the top and bottom. To...

Dropping the price a little because I made a large purchase and would like some funds back in the bank.

R465 is orange white brown and measures 390 out of circuit. My chassis does switch 15/24 by moving the jumper. C532 is 8.2nF same as listed. Not sure why this whole circuit is missing on mine but seems to be connected to H Phase which is working fine. Oh yes, also. C446 on the schematic is...

Bump

This is incredible work. I have an MS8-29 I'm working on right now and it's already helped me fix a protection fault. Now it has a strange jittery SPC/H Size fault I am trying to hunt down. I did find these differences on the MS8-29 schematic: R465 on my board is a 390ohm VR434 on my board is...

Finished refurbishing this sad NAC I picked up recently at a local pinball show, but it doesn't really have a place in my collection, so I'm looking to sell it. Here is an overview of the condition: Cabinet originally imported in the early 2010s, 88k on the coin counter Overall good condition...

Many hours of tracing and cutting and crimping later, the second wiring harness is done!!! This means the original can go back in the cabinet. It's assembled as far as it's gonna be for now. A friend tipped me off to gray wire tiedowns which appear to be exactly the same as the OEM ones...

Already have a bid on it :)

Need one for a chassis that just arrived and is missing one. Thanks

Cool cabinet! The Candy 25 is one of my favorites with the best rotation mech of any cab. If you want to take it the next step, wet sanding and polishing can restore even very badly scratched transparent plastics. Here's a couple OEM Astro toppers I salvaged by wet sanding...

Get a DA polisher. I used to think Novus was kinda crap until I used it on a machine and it made a huge difference. If you're going all the way up to 4000 grit you should be able to go straight to Novus 2 and not have swirls, but I usually stop at 2000 or a quick pass with 3000 and then cut with...

All 3 tested working, have multi bios installed and have been dusted out inside. All will be shipped without batteries. Asking $120 shipped each within the US. SOLD

Thanks all. I went ahead and placed those stickers. I should have some dark gray spraypaint sitting around I can use for the speaker grilles. I did know about the black paper inside the speaker pods and was meaning to remake those as well on the cricut. I would prefer to replace the floor...