Recent content by TSJO

Nothing else at all, I tested it first without the key wires using the decrypted rom set then when that was confirmed working i soldered then key wires abs used the other rom pack I will say that the female connectors (internal to the plastic housing) on my kit’s top board were quite flimsy and...

I used a rev 4 board in the end, I can’t give you super technical help but it might be worth posting (sorry for advocating dupe posting) on the champ edition thread, I got super helps on there 👍🏻👍🏻😂

I was getting various issues with my first attempt, one was yellow screen, I can’t remember and I’ll have to go back to the big thread but in the end I think it was just seating issues (as well as what turned out to be some bad NG roms on a rev 6 XvSF board that was previously 100%) Champ...

PM

I’ve probed the pins and points on the board and all are ok for continuity

Yeah I’m going to give that a fettle first Any idea where I could get them, should I need to replace?

Well, it must be a b board issue on that rev 7 xvsf board because it’s working like a charm (minus the auto reboot) on my rev 4 b board

I’ve got a rev 4 phoenixed board, going to try the multi on that (without soldering initially)

Hi, I didn’t notice the ribbon cable but it’s straight out of the shipping box, I’ve just been and had a look and it is dimpled quite badly I’ve tried with the key writing/reset cable and without and no joy

I’ll try a couple of smaller things first like different sd card and a gpal (if anyone could look t me to a place to buy one uk?) If the worst comes to it and the ram is dead is this something that I can change out and if so could someone point me in the direction of replacements?

Hi, board was 100% before multi?

Hi, thanks for the reply SD card was supplied by supplier of board, it’s not with me currently but I think it’s a transcend 8gb SDHC, I’ll get to check shortly - *edit* It’s a class 10 SDHC 8gb by transcend I removed everything as per the new version of the manual I’m currently going through...

Hi all, new to the forum but I’ve just received my darksoft kit from saveyourgames.it, including SD card from them I’ve installed onto a previously 100% working Xmen v SF rev 7 b board with battery removed, exc5 shorted to clear, DuPont wires connecting key writing & the Darksoft 2020...